5
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
SELF-DIAGNOSTIC MODE
5 - 9
5.5 Test print mode (test mode 04)
<Operation procedure>
• When an error occurs, it is indicated on the panel, but the recovery operation is not
performed. Turn OFF the power and then back ON to clear the error.
• During test printing, the [C] button is disabled when “Wait adding toner” is displayed.
* Refer to "Appendix" in this manual for the codes available in the test print mode.
The embedded test pattern can be printed out by keying in the following codes in the test print mode
(04).
[0][4]
[POWER]
[POWER] OFF/ON
(Exit)
(Code)
[START]
[CLEAR]
Operation
Continuous
Test Printing
To Next Page
Loading...
Need help?
General
