Toshiba e-STUDIO656 - Original Width Detection Sensor-1 (SR6)

4
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4 - 153
4.12.42 Original width detection sensor-1 (SR6)
4.12.43 Original registration sensor (SR5)
4.12.44 Original exit sensor (SR12)
(1) Take off the feeder lower guide unit.
( P.4-151 "4.12.39 Feeder lower guide
unit")
(2) Disconnect 1 connector. Lift the actuator,
release 2 latches and take off the original
width detection sensor-1.
Fig. 4-435
(1) Take off the feeder lower guide unit.
( P.4-151 "4.12.39 Feeder lower guide
unit")
(2) Disconnect 1 connector. Release 2 latches
and take off the original registration sensor.
Fig. 4-436
(1) Take off the assembly of the exit guide and
the exit/reverse guide.
( P.4-123 "4.12.11 Exit guide / Exit/reverse
guide / Reading end guide")
(2) Remove 2 screws and take off the 2 leaf
springs.
Fig. 4-437
Original width detection sensor-1
Original registration sensor