Toshiba e-STUDIO656 - Original Exit Solenoid (SOLR3)

4
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4 - 147
4.12.33 Original exit solenoid (SOLR3)
(1) Take off the RADF board bracket.
( P.4-117 "4.12.3 RADF rear cover")
(2) Disconnect 1 connector.
(3) Remove 2 screws and take off the original
exit solenoid with the bracket.
Fig. 4-417
(4) Remove 2 screws and take off the bracket
from the original exit solenoid.
Fig. 4-418
Note:
Before taking off the solenoid, read the scale.
When reinstalling, align it with the
corresponding position on the scale.
Fig. 4-419