6
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
ADJUSTMENT
6 - 35
6.6.2 Density adjustment
Adjusts the center density and the variation of density adjustment buttons.
< Adjustment Mode (05) >
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Key in a code and press the [START] button.
(3) Key in an adjustment value.
(To correct the keyed-in value, press the [C] button.)
(4) Press the [OK] or [INTERRUPT] button to store the value. The equipment goes back to the ready
state.
(5) Shut down (turn the power OFF), back ON, and then perform the scanning job.
(6) If the desired image density has not been attained, repeat step (1) to (5).
Color
Mode
Original mode
Item to be adjusted Remarks
Text/
Photo
Text Photo
User
Custom
Color 8339 8340 8341 8380 Manual density
center value
The larger the value is, the darker
the image becomes.
Acceptable values: 0 to 255
(Default: 128)
- 8344 8345 8381 Manual density light
step value
Sets the changing amount by 1
step at the density adjustment on
the control panel. The larger the
value is, the lighter the light side
becomes.
Acceptable values: 0 to 255
(Default: 20)
- 8348 8349 8382 Manual density dark
step value
Sets the changing amount by 1
step at the density adjustment on
the control panel. The larger the
value is, the darker the dark side
becomes.
Acceptable values: 0 to 255
(Default: 20)
Black
Gray
Scale Item to be adjusted Remarks
Original mode
Text/
Photo
Text Photo
User
custom
7444 7445 7446 7475 7447 Manual density
center value
The larger the value is, the darker
the image becomes.
Acceptable values: 0 to 255
(Default: 128)
7456 7457 7458 7478 7459 Automatic density
mode
To Next Page
Loading...
