Toshiba e-STUDIO656 - Page 160

e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 14
Notes:
Be sure to install the lamp harness by
following the procedure below.
1. Using alcohol, clean the area where the
seal is to be attached.
2. Align the black line on the lamp harness
with the position as shown in the figure,
and fix it with a seal.
3. Align the bent portion of the lamp harness
with the position as shown in the figure,
and fix it with a seal.
4. After the installation, move carriage-1
towards the left and confirm that there is
no abnormality in the lamp harness, such
as twisting.
Fig. 4-37
Fig. 4-38
(7) Rotate the carriage-1 in the direction shown
in the figure at right, not to touch the mirror.
Then take off the carriage-1.
Note:
When replacing the mirror-1, replace the
carriage-1 together with mirror-1. Mirror-1
should not be removed.
Fig. 4-39
Lamp harnessLamp harness
Punched mark
Hole
Black Line
Seal
Lamp harness
Punched mark
Seal