e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 16
(4) Disconnect the connector of the exposure
lamp.
When disconnecting the connector, pay
attention not to give load to the carriage
frame.
(5) Release the harness from the harness
clamp.
Fig. 4-43
(6) Move the carriage-1 to the position where
the side of the frame is cut out.
Fig. 4-44
(7) Remove 1 screw.
(8) Lift up the front side of the exposure lamp
and take off by sliding it.
Fig. 4-45
Exposure lamp
To Next Page
Loading...
