4
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4 - 47
[ 2 ] Registration sensor (S18)
(4) Slide the registration roller to the front side,
then take off the rear side to remove it.
Fig. 4-133
(5) Take off 2 bushings, gear and pin.
Fig. 4-134
(1) Remove 1 screw and take off the sensor with
the bracket.
(2) Disconnect 1 connector, release the latch
and take off the sensor.
Fig. 4-135
Registration roller
(
rubber
)
Bushing
Bushing
Pin
Gear
Registration sensor
To Next Page
Loading...
