e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 98
When the cleaning web has been installed,
be sure that the web is tightly reeled.
Fig. 4-276
(4) Remove 2 E-rings, 2 washers, and 2 one-
way bearings. Then take off the web pushing
roller.
1. When assembling the unit, be sure that
the one-way bearings are in the correct
directions.
2. Be sure that the web pushing roller rolls
only in the direction of the arrow in the
figure.
Fig. 4-277
One-way bearing
One-way bearing
Web pushing roller
Mark side
Washer
Mark side Washer
To Next Page
Loading...
