e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
SELF-DIAGNOSTIC MODE
5 - 22
When "2" is selected, the menu below appears. To start, press the [START] button.
Fig. 5-12
When the operation is finished, the result appears on the menu.
Fig. 5-13
After this operation, the equipment becomes reusable without reinstalling the firmware.
HDD Assist Mode
Current HDD type: ADI HDD
Select number (1-2) and press START key
1. Revert factory initial status HDD
2. Remove key
System Firmware Version
Update Mode
: xxxx(x.x.x.x)
: 4c Mode
=>
Confirmation Screen
Are you sure ???
Press START to continue
Press STOP to cancel
HDD Assist Mode
Current HDD type: ADI HDD
Select number (1-2) and press START key
1. Revert factory initial status HDD
2. Remove key
System Firmware Version
Update Mode
: xxxx(x.x.x.x)
: 4c Mode
=>
Data in the HDD has been erased.
Press SoftPower Key to Switch Off
To Next Page
Loading...
