e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
SELF-DIAGNOSTIC MODE
5 - 30
[D] 3. SRAM Re-Initialize Support
Select this to clear an F900 error which occurred when SYS-SRAM and the SYS board are replaced at
the same time, since this error cannot be cleared in the 3C mode.
• After updating with a download jig and clearing the SRAM data, select this item.
• After clearing the SRAM data, initialize SRAM following its replacement procedure.
To Next Page
Loading...
