8
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
ERROR CODE AND TROUBLESHOOTING
8 - 81
[EC20] Inserter reverse path delay jam-1
[EC30] Inserter reverse path stop jam-1
[EC40] Inserter reverse path delay jam-2
[EC50] Inserter reverse path stop jam-2
[EC60] Inserter transport delay jam-1
[EC70] Inserter transport stop jam-1
[EC80] Inserter transport delay jam-2
[EC90] Inserter transport stop jam-2
Are the transport roller and reverse roller tainted?
YES Clean up the rollers.
NO
Is the harness between the inserter control board and reverse path sensor is open-
circuited?
YES Replace the harness.
NO
Is the reverse path sensor working improperly?
YES Replace the reverse path sensor.
NO
Replace the inserter control board.
Is the transport roller tainted?
YES Clean up the roller.
NO
Is the harness between the inserter control board and transport sensor is open-circuited?
YES Replace the harness.
NO
Is the transport sensor working impropely?
YES Replace the transport sensor.
NO
Replace the inserter control board.
To Next Page
Loading...
