9
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
REPLACEMENT OF PC BOARDS / HDD
9 - 31
(6) The Remove screen is displayed. Then press the [YES].
If this screen is not displayed, check that the one-time dongle is installed in the equipment
properly.
(7) After 10 to 40 seconds have passed, the screen for notifying the success of the performance is
displayed. Then press the [OK].
If the screen for notifying a failure of the performance is displayed, quit this operation by pressing
the [CLOSE]. Then check that the one-time dongle, which you used for uploading the selected
license, is installed in the equipment.
(8) Check that the returned license is not displayed on the screen.
If there are any other licenses to be returned, repeat from step (4).
If there are no other licenses to be returned, press the [CLOSE], and then turn the power OFF.
(9) Replace the equipment.
(10) Turn the power ON while pressing [0] and [8] simultaneously.
(11) Enter the password, and then press the [OK].
(If the password is not set for Service, press the [OK] without entering anything.)
(12) Key in [3840], and then press the [START] button.
(13) Press the [INSTALL].
(14) Install the one-time dongle in the equipment (the one which you used for returning the selected
license before replacing the equipment). Then press the [OK].
(15) Select the license to be installed, and then press the [INSTALL].
(16) The screen for notifying that the installation will be started is displayed. Then press the [YES]
button.
(17) After 10 to 40 seconds have passed, the screen for notifying the success of the performance is
displayed. Then press the [OK]. If the screen for notifying a failure of the performance is
displayed, quit this operation by pressing the [NO]. Then check that the one-time dongle is
installed properly in the equipment.
(18) Check that the installed license is displayed on the license list.
If there are any other licenses to be installed, repeat from step (13). If there are no other licenses
to be installed, press the [CLOSE], and then turn the power OFF.
To Next Page
Loading...
