11
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
FIRMWARE UPDATING
11 - 41
(6) After the update is completed properly, the LED on the download jig blinks (at an interval of
approx. 1 sec.).
The LED starts blinking approx. 50 sec. after the update starts. It is assumed that the update has
failed if it does not start blinking even though 2 min. has passed. In this case, shut down the
equipment and check the following items. Then clear the problems and restart updating from the
beginning.
• Is the download jig connected properly?
• Is the ROM installed to the download jig properly?
• Is the updating data written on the ROM of the download jig properly?
• Do the download jig, RADF and the equipment operate properly?
(7) Press the [ON/OFF] button on the control panel to shut down the equipment.
(8) Remove the download jig and install the RADF rear cover.
[B] Confirmation of the updated data
After the updating is completed, check each data version in Setting Mode (08) to confirm that the data
were overwritten properly.
P.11-50 "11.6 Confirmation of the updated data"
To Next Page
Loading...
