Toshiba IPedge - Set Network Time; Upgrade Software

UPGRADE SOFTWARE Set Network Time
Installation Manual June, 2011 12-3
5. Click on submit.
6. Click on the Burn icon at the top of the screen to save the settings.
7. Log in using the new IP address.
Set Network Time Set the Network Time Protocol server addaress.
1. Select Configuration, click on the Basic radio button.
2. Click on Application Settings.
3. Enter the IP address for the NTP server you want to use.
4. Enter the UTC offset. Entr the update interval. An update interval of
24 hours is a good choice.
5. Click on the Submit button.
UPGRADE SOFTWARE If necessary, upgrade the MP118 software. If the upgrade is not needed
go to “MP118 MEDIA SETTINGS” on page Chapter 12 – 4.
1. Login to the MP118.
2. Select MANAGEMENT > SOFTWARE UPDATE > SOFTWARE
UPGRADE WIZARD.
3. In the Software Update Wizard click on the Start Software Upgrade
button.