MEETING INITIAL CONFIGURATION MEETING IP Address Change Procedure
4-16 Installation Manual June, 2011
MEETING IP Address
Change Procedure
1. In to Enterprise Manager, select Applications > Meeting > IPedge.
2. In the Welcome Screen, select System Configuration the screen
below will display. Enter the following:
System Name - The Meeting service name
Server Name - The meeting admin server name. This is the name
registered in the DNS server.
Dial in Number - The pilot number of the voice conference station
group
Web Conference Server - The web conference server name. This is
the name registered in the DNS server.
3. Ensure that the Stack IP Address and Gateway Address are set to
the IPedge server IP Address. Click Submit.
4. Under System Configuration, select the Circuit Groups Tab.
5. Click on the Circuit Group to open the Edit Circuit Group Page.
IPedge Server Addr
IPedge Gateway Addr
admin.SERVER_NAME.prv
webconf.SERVER_NAME.prv
6000 (Pilot DN - Example only)
Select local time zone
To Next Page
Loading...
