SETUP THE I/O PORT
13-2 Installation Manual June, 2011
5. Select Net Server from the Application Name list (shown below).
6. Add the IP Address: 127.0.0.1
7. Click OK.
SETUP THE I/O PORT 1. Using Enterprise Manager, go to System > I/O Device.
2. Click the New icon.
3. Choose any one of available CTI#0~8 for the Logical Device No.
4. Set the Application Type to Server
5. Server Port No. must be 1100 for Net Server.
Important! Do not configure any other application including
Attendant Console to use Port 1100.
6. Click the Save icon.
NET SERVER
ADMINISTRATION
Net Server administration allows the administrator to configure the Net
Server to control the behavior of Call Manager client application. It is
designed to provide the basic operations of Call Manager without any
configuration. If the administrator requires the advanced operations such
as pushing settings to the clients, Net Server administration needs to be
used.
To access Net Server
Using Enterprise Manger, go to Application > Net Server menu.
NET SERVER MENU Net Server menu provides access to the basic setup for Net Server
application on IPedge server.
To Next Page
Loading...
