EM SERVER EC Rear Panel Connections
Installation Manual June, 2011 2-3
Disk drive activity LED - Lights while a hard disk drive or the DVD-ROM
drive is accessed.
NIC 1 - Indicates activity on the LAN 1 connection
NIC 2 - Indicates activity on the LAN 2 connection
Both NIC connections support 10BASE-T, 100BASE-TX, and 1000BASE-
T, RJ45 output
EC Rear Panel
Connections
The rear panel connectors and indicators are described below.
• AC power cord connector and AC power input switch
• Keyboard and PS/2 Mouse
• USB 0 and USB 1
• COM1
• VGA
• LAN1 and LAN2
• IPMI
EM SERVER For IPedge systems of up to 1000 users. This server has two, front
access 3 GB hard disk drives. RAID 1 configuration is available as an
option.
The IPedge EM server supports IPMI (Intelligent Platform Management
Interface) 2.0.
Dimensions • Height 1.7" (43 mm) 1U
• Width 17.2" (437 mm) Fits a standard 19 inch rackmount.
• Depth 25.6" (650 mm)
• Gross Weight 33lbs (15.0kg)
Environmental
Specifications
• Operating Temperature: 10° to 35°C (50° to 95°F)
• Storage Temperature: -20° to 60°C (-4° to 140°F)
• Operating Relative Humidity: 8% to 90% (non-condensing)
• Server generates approximately 778 BTUs per hour (867 BTUs Max.)
Input Power The IPedge EM server has two redundant, hot-swap power supplies. The
server can run indefinitely on one supply.
• 100 ~ 240 VAC, 50 ~ 60Hz
• Peak load: 250 W, 2.1 Amp at 120 VAC (tested)
• Maximum Inrush Current: 10.4 Amp
To Next Page
Loading...
