IPedge CONFIGURATION for FXS Verify Station Registration
12-12 Installation Manual June, 2011
Assign the next analog DN channel 2. Next to channel 3, and so on.
19. Click on the Submit button.
20. Select Protocol Configuration > Hunt Groups > Hunt Group
Settings.
Hunt Group ID = 2
Channel select mode = By Dest. Phone Number
Registration Mode = Per Endpoint
Gateway name = The IP address of the IPedge server
21. Click on the Burn icon at the top of the screen.
22. When the setup is complete Click on the Device Action icon. Click
on Reset.
IPedge CONFIGURATION
for FXS
1. Set up a SIP Station in the IPedge server for each analog station
connected through the gateway. Select Station > Station
Assignment. Setup station data then, click on the save icon.
2. In the IPT Data tab set the Prime DN of the first DN as the SIP
Terminal URI and the SIP Terminal Password. Click on the Save icon.
3. Repeat for each of the station DNs connected through the gateway.
Verify Station Registration This procedure can be used ti verify that the stations are registered and
ready for use.
1. Login to the gateway.
2. Select Status & Diagnostics > Gateway Statistics > Registration
Status.
3. Verify the the FXS ports you just configured show a status of
Registered.
Note: FXO ports do not register.
To Next Page
Loading...
