MP118 MEDIA SETTINGS Endpoint Numbers
Installation Manual June, 2011 12-7
Enter the Destination Number for Port 5 FXO. Refer to the URI table
in the IPedge database.
24. Click on Submit.
Endpoint Numbers 25. Select Protocol Configuration > Endpoint Number > Endpoint
Phone Number.
In the Channel number column enter (the same as the FXO Port
number)
Phone number = The number assigned in the IPedge URI table
(4001 for example)
Hunt Group ID = 1
Tel Profile ID = 0
Hunt Group Settings 26. Select Protocol Configuration > Hunt IP Groups > Hunt Group
Settings
Hunt Group ID = 1
Channel select mode = Ascending
27. Select Protocol Configuration > Advanced Applications > FXO
Settings
Dial Mode = One Stage
Leave the other parameters at default values
28. Click on Submit.
29. Click on the the Burn Icon at the top of the screen. Then use the
"device action" drop down box and select reset. In the next screen
click on Reset.
A value from the URI table
4001 for example
Note: Start the Destination Phone Number entries with the
first FXO port.
To Next Page
Loading...
