3 Tests and Diagnostics 3.31 SETUP
3-102 [CONFIDENTIAL] QOSMIO F20 Maintenance Manual (960-526)
to move the cursor to the right and ? to move the cursor to the left when you set the
date and time.
For the Alarm Time, set the time to turn on the power automatically. The “second”
cannot be set. When it is set to “Disabled”, the time to turn on automatically is not
set.
For the Alarm Date Option, set the date to turn on the power automatically.
When it is set to “Disabled”, the time to turn on automatically is not set.
NOTE: 1. Do not remove the AC adaptor and battery pack at the same time when you
use this feature. If you do so, data saved by the resume function will be lost.
You must also reset this option.
2. If you have set a password and the computer boots by the Auto Power On
function and hibernation is on, the computer will start with the instant
security function enabled. When the password = message is displayed, enter
the password to use the computer.
3. This option is enabled only once, the setting is reset, after booting up.
(d) Diagnostic Mode
This option enables/disables the HW Diagnostic test function.
Disabled Disables the HW Diagnostic test function. (Default)
Enabled Enables the HW Diagnostic test function.
8. Configuration
This option lets you set the device configuration.
All Devices BIOS sets all devices.
Setup by OS Initializes devices, which is needed to load an operating
system. Operating system initializes other devices.
NOTE: When using installed OS, selecting “Setup by OS” is recommended. But when
executing test programs, select “ALL Devices”.
9. Drives I/O
This option displays the address and interrupt level for hard disk drive and optical disk
drive. It is for information only and cannot be changed.
Built-in HDD This cannot be changed.
To Next Page
Loading...
Need help?
General