⎯ 49 ⎯
6 F 2 S 0 7 1 5
• The screen returns to the [Setting menu] screen. Click the [Send] or [Send all] button and the
[Confirmation] dialog box will appear.
Note: The [Send] button is used to send only changed setting data. While, the [Send all] is used to
send all setting data including the changed one. It is recommended to use the [Send] button
when the changed item is not so many.
• Click the [Yes] button to send the settings to the relay. The settings are changed in the relay
and the screen returns to the [Top menu] screen.
Caution: If canceling the setting change or disconnecting the RS232C cable while sending new setting
data, view and recheck the setting data. The setting data might have partly changed to new one.
Notion:
After sending setting data from a PC, the display of the relay is not changed instantaneously while the
relay panel is displaying settings. (The settings are loaded on a memory, but the panel still displays the
settings before the change.) To confirm the settings change on the display of the relay, go back to the top
menu first, and then move to the desired screen.
Version
Click the [Version] button on the [Setting menu] screen to view the relay serial number and
software type-form.
Click the [Setting menu] button to return to the [Setting menu] screen.
To Next Page
Loading...