⎯ 60 ⎯
6 F 2 S 0 7 1 5
[File] menu or [Compare] icon on the Tool Bar (see the following figure) and choosing the file in
the displayed [Open] dialog box.
When reading the selected file on the setting sub-menu screen, the difference items are listed as the
result of the check on the [Different items] screen if there is any difference between the displayed
setting data and compare setting data.
Note: The different items can be saved as .csv file by click the [Save] button.
Different items
Comparing can do the same operation on the off-line setting screen.
Note:
(1) This operation assumes that main software revision of the saving setting file identifies
with one of the current displayed relay. The following message appears if each revision
is different, choose the [OK] button when comparing forcibly.
If the relay type or rating is different, the alarm message appears and not compare.
(2) The difference of setting values is only detected on the basis of the current displayed
configuration data. The setting range and setting step do not compare.
(3) If the main software revision is different, it may well be that the different setting values
or unmounted setting value are compared.
(4) When comparing the setting values on the off-line Default Set. Screen and saved file, the
difference of the main software revision is not checked.
Caution for CSV file saving:
If “Decimal symbol” of “Regional and language options” in “Control panel” is set to “,”
(Comma), a punctuation mark of CSV file (Comma (,) or Semicolon (;)) selection screen is
displayed. If comma (,) selected, the decimal symbol is automatically changed to period (.).
To Next Page
Loading...