3 Tests and Diagnostics 3.1 The Diagnostic Test
3-4 [CONFIDENTIAL] TECRA A9(S5/P5/S200) Maintenance Manual (960-633)
3.1.2 H/W (Hardware) initial information setting tool
The H/W initial information setting tool consists of the following programs.
Initial configuration
DMI information save
DMI information recovery
System configuration display
E2PROM test (MAC/GUID/DMI)
You will need the following equipment to perform some of the programs.
The Diagnostics Disk (Main T&D)
3.1.3 Heatrun test program
The heatrun test starts automatically after the selection.
You will need the following equipment to perform this program.
The Diagnostics Disk (Main T&D)
To Next Page
Loading...
