4.30 Hinge 4 Replacement Procedures
4.30 Hinge
Removing the Hinge
To remove the hinge, follow the steps below and refer to Figure 4-52 and 4-53.
1. Remove the following screws.
• M2.5×4B FLAT HEAD screw ×2
• M2.5×6C Tapping screw ×4
2. Stand the LCD mask and remove it.
CAUTION: When standing the LCD mask, be careful not to hold the top portion.
M2.5×6C Tapping
M2.5×4B FLAT HEAD
M2.5×6C Tapping
LCD mask
M2.5×6C Tapping
M2.5×4B FLAT HEAD
Figure 4-52 Removing the LCD mask
TECRA A9/TECRA S5/TECRA P5/Satellite Pro S200 Maintenance Manual (960-633) [CONFIDENTIAL] 4-93
To Next Page
Loading...
