4.14 Touch pad 4 Replacement Procedures
4 Replacement Procedures
4.14 Touch pad
Removing the Touch pad
To remove the touch pad, follow the steps below and refer to Figure 4-22 and 4-23.
1. Lift the tip portions up first and remove the touch pad cover while releasing latches.
2. Disconnect the touch pad cable from the connector CN3240 on the system board.
3. Remove the following screw and touch pad assembly from the slot.
• M2.5×10B FLAT HEAD screw ×1
Touch pad cover
Touch pad assembly
Tip portion
M2.5×10B FLAT HEAD
Touch pad cable
CN3240
Figure 4-22 Removing the touch pad (1)
TECRA A9/TECRA S5/TECRA P5/Satellite Pro S200 Maintenance Manual (960-633) [CONFIDENTIAL] 4-37
To Next Page
Loading...
