3.20 ONLY ONE TEST 3 Tests and Diagnostics
TECRA A9(S5/P5/S200) Maintenance Manual (960-633) [CONFIDENTIAL] 3-49
3.20.9 Subtest 9 Fan control
This subtest checks if FAN works properly.
The following message appears in the display in order.
! Start low-speed rotation……….Waits 8 seconds
! Start reading of rotation…………Waits 3 seconds
! Start Hight-speed rotation……..Waits 8 seconds
! Start reading of rotation…………Waits 3 seconds
FAN Low-speed----> Target Low: 3000 Rpm Result Low: XXXX Rpm OK!
FAN High-speed---> Target High: 3500 Rpm Result High: XXXX Rpm OK!
OK message appears in the display if the test ends without a defective.
NG message appears in the display if a defective is found during the test.
3.20.10 Subtest A Smart Card (SmartCard model only)
This section describes how to perform the SmartCard test. To execute the
SmartCard test, refer to the following description.
SmartCard is put into a slot.
SmartCard test is read from CD media..
If it is OK, the following message will come out.
ATR = xxxxxxxxxxx
Return : Success
If it is not Card, the following message will come out.
Please Insert Smart card!
Waiting for you…
If it is Card Back, the following message will come out.
Maybe Smart card Inserted Back wards!
Return : Get ATR failed!
If it is NG, the following message will come out.
02SCR Initial failed!!!
To Next Page
Loading...
Need help?
General
