4 Replacement Procedures 4.7 MDC/Memory module
3. Remove the following screws securing the MDC.
• M2×4B BIND screw ×2
4. Lift the MDC straight above and remove it from the CN3010 on the system board.
5. Disconnect the MDC cable from the connector on the MDC.
MDC
CN3010
MDC cable
M2×4B BIND
Figure 4-9 Removing the MDC
4-18 [CONFIDENTIAL] TECRA A9/TECRA S5/TECRA P5/Satellite Pro S200 Maintenance Manual (960-633)
To Next Page
Loading...
