Toshiba Tosvert VF-S15 - Page 269

E6582175
G-10
7
 List of output terminal function settings
List of detection levels for output terminal selection
Parameter
programmed value
Function
Parameter
programmed value
Function
Positive
logic
Negative
logic
Positive
logic
Negative
logic
Frequency lower limit   Light load output
Frequency upper limit    Heavy load output
Low-speed detection signal     Lower limit frequency stop
Output frequency attainment signal
(acceleration/deceleration completed)
  Power failure synchronized operation
Set frequency attainment signal     Traverse in progress
    Fault signal (trip output)     Traverse deceleration in progress
    Over-current detection pre-alarm   Parts replacement alarm
    Overload detection pre-alarm     Over-torque detection pre-alarm
    Overheat detection pre-alarm   Frequency setting mode selection 1/2
    Overvoltage detection pre-alarm   Panel / remote selection
    Power circuit undervoltage detection   Forced continuous operation in progress
    Small current detection     Specified frequency operation in progress
    Over-torque detection     Signal in accordance of PID set value
    Braking resistor overload pre-alarm     Fault signal (output also at a retry waiting)
    In course of retry   PTC input alarm signal
    Run/Stop   Safe torque off signal
    Serious failure   Analog input break detection alarm
    Light failure   F terminal status
    Cooling fan ON/OFF     R terminal status
    In jogging operation   Cooling fan replacement alarm
    Operation panel / terminal block
operation
  Number of starting alarm
    Cumulative operation time alarm     Acceleration operation in progress
    Communication option
communication error
  Deceleration operation in progress
    Forward/reverse run     Constant speed operation in progress
    Ready for operation 1    DC braking in progress
    Ready for operation 2 to  Factory specific coefficient *1
    Brake release 180 181 Integral input power pulse output signal
    Pre-alarm 182 183 Shock monitoring pre-alarm signal
    RS485 communication error to  Factory specific coefficient *1
    Designated data output 1  Always OFF
    Designated data output 2  Always ON
*1: Factory specific coefficients are manufacturer setting menus. Do not change the value of these parameters.
<Explanation of terminology>
 Alarm …... Alarm output when a setting has been exceeded.
 Pre-alarm …... Alarm output when the inverter may cause a trip during continued operation.