Toshiba Tosvert VF-S15 User Manual

E6582175
J-7
10
STATUS
RUN
R
U
N
E
A
S
Y
S
T
O
P
M
O
D
E
PRG
MON
%
H
z
S
T
A
T
U
S
R
U
N
RUN
EASY
STOP
MODE
P
R
G
M
O
N
%
H
z
S
T
A
T
U
S
RUN
R
U
N
E
A
S
Y
F
L
E
L
A
F
L
C
STO
SU
R
Y
R
V
S
T
O
P
M
O
D
E
PRG
MON
%
Hz
■ Mounting, wiring and removing of the Communication option adaptor (SBP009Z)
Warning
Prohibited
 Do not connect any communication device other than applicable communication options to
the option adapter.
This can result in malfunction or accident.
Mandatory
Action
 The mounting/removing of option must be performed without supplying power(Turn off all
input power, wait at least 15 minutes, confirm that the charge lamp of inverter is no longer lit).
The inverter and option can become damaged.
 Do not use tool for the mounting/removing of option .
The inverter and option can become damaged.
After mounting option adapter, the depth of inverter is increased by 25.5mm
Note) Refer to Instruction Manual for option adapter (E6581838) about detailed specifications
3PH-200V 0.75kW inverter is shown in the picture.
2) Unlock the front cover and open it.
1) Insert option into option adapter.
4) Close the front cover and lock it.
3) Remove the option connector cover
on the front cover from the back side.
Note: Mount option adapter to inverter after
option insertion.
Insert the option straightly and slowly
along the guide inside option adapter.
Follow this instruction, the connecter
can become damaged.
Option adapter
Option connector
cover
■ Mounting of option
Option

Toshiba Tosvert VF-S15 Specifications

General

Category	Inverter
Control Method	V/f control, Sensorless vector control
Cooling Method	Forced air cooling
Model	Tosvert VF-S15
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overheat
Communication Options	Modbus RTU
Overload Capacity	150% for 1 minute
Braking Unit	Built-in braking transistor
Output Voltage	3-Phase, same as input voltage
Operating Temperature	-10 to +50°C (14 to 122°F)
Storage Temperature	-20 to 65°C (-4 to 149°F)
Humidity	5 to 95% RH (non-condensing)
Altitude	Up to 1000m above sea level
Input Voltage	3-Phase 200 to 240 VAC, 3-Phase 380 to 480 VAC
Weight	Varies depending on model (e.g., 0.8 kg to 16 kg)