E6582175
D-4
4
Standard setting mode : The mode changes to the Standard setting mode when
the EASY key is pressed and "std" is displayed.
Both basic and extended all parameters are displayed.
Basic parameters : This parameter is a basic parameter for the
operation of the inverter.
Refer to chapter 5 for details.
Refer to section 11.2 for parameter tables.
Extended parameters : The parameters for detailed and special
setting.
Refer to chapter 6 for details.
Refer to section 11.3 for parameter tables.
Note) There are the parameters that cannot be changed during inverter running for reasons of safety. Refer to section 11.9.
To Next Page
Loading...
