Toshiba Tosvert VF-S15 User Manual

E6582175
D-15
4
psel =0
* When the power is turned on, the inverter is in standard mode. Press the EASY key to switch to easy setting
mode.
psel =1
* When the power is turned on, the inverter is in easy setting mode. Press the EASY key to switch to standard
mode.

psel =2
* Always in easy setting mode.
However, it can be switched to standard setting mode by EASY key if it is set to psel=0, 1. When psel is
not displayed in Easy setting mode, undo is displayed and it can be temporarily switched to standard setting
mode by EASY key after center of the setting dial is pushed for five seconds or more.

Toshiba Tosvert VF-S15 Specifications

General

Category	Inverter
Control Method	V/f control, Sensorless vector control
Cooling Method	Forced air cooling
Model	Tosvert VF-S15
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overheat
Communication Options	Modbus RTU
Overload Capacity	150% for 1 minute
Braking Unit	Built-in braking transistor
Output Voltage	3-Phase, same as input voltage
Operating Temperature	-10 to +50°C (14 to 122°F)
Storage Temperature	-20 to 65°C (-4 to 149°F)
Humidity	5 to 95% RH (non-condensing)
Altitude	Up to 1000m above sea level
Input Voltage	3-Phase 200 to 240 VAC, 3-Phase 380 to 480 VAC
Weight	Varies depending on model (e.g., 0.8 kg to 16 kg)