"
Indicates the SFP port is not connected to a device.
"
Indicates the SFP port is at the speed of 1000Mbps.
"
Indicates the SFP port is at the speed of 100Mbps.
When the cursor moves on the port, the detailed information of the port will be displayed.
Figure 4-2 Port Information
" Rqtv"Kphq"
Rqtv<"
Displays the port number of the switch.
V{rg<"
Displays the type of the port.
Tcvg<"
Displays the maximum transmission rate of the port.
Uvcvwu<"
Displays the connection status of the port.
Click a port to display the bandwidth utilization on this port. The actual rate divided by theoretical
maximum rate is the bandwidth utilization.
Figure 4-3 displays the bandwidth utilization monitored
every four seconds. Monitoring the bandwidth utilization on each port facilitates you to monitor the
network traffic and analyze the network abnormities.
Figure 4-3 Bandwidth Utilization
" Dcpfykfvj"Wvknk|cvkqp"
Tz<"
Select Rx to display the bandwidth utilization of receiving packets
on this port.
Vz<"
Select Tx to display the bandwidth utilization of sending packets
on this port.
12
To Next Page
Loading...
