Figure 6-14 Enable VLAN Mapping for Port
Select your desired port for VLAN Mapping function. All the ports are disabled for VLAN Mapping
function by default.
Eqphkiwtcvkqp"Rtqegfwtg"qh"XNCP"XRP"Hwpevkqp<"
Uvgr" Qrgtcvkqp" Fguetkrvkqp"
1 Enable VPN mode. Required. On the XNCP→XNCP"XRP→XRP"Eqphki"page,
enable the VPN mode.
2 Configure the global TPID. Optional. On the XNCP→XNCP" XRP→XRP" Eqphki" page,
configure the global TPID basing on the devices connected
to the up-link port.
3 Set the VPN up-link port. Required. On the XNCP→XNCP"XRP→XRP"Eqphki"page,
specify the desired port to be the VPN up-link port. It’s
required to set the port connected to the backbone
networks to be up-link port.
4 Create VLAN Mapping
entries.
Required. On the XNCP→XNCP" XRP→XNCP" Ocrrkpi"
page, configure the VLAN Mapping entries basing on the
actual application.
5 Create SP (Service
Provider) VLAN.
Optional. On the XNCP→:2403S" XNCP" page, create the
SP VLAN. For the steps of creating VLAN, please refer to
802.1Q VLAN
.
Eqphkiwtcvkqp"Rtqegfwtg"qh"XNCP"Ocrrkpi"Hwpevkqp<"
Uvgr" Qrgtcvkqp" Fguetkrvkqp"
1 Create VLAN Mapping
entries.
Required. On the XNCP→XNCP" XRP→XNCP" Ocrrkpi"
page, configure the VLAN Mapping entries basing on the
actual application.
2 Enable VLAN Mapping
function for port.
Required. On the XNCP→XNCP"XRP→Rqtv"Gpcdng"page,
enable VLAN Mapping function for the ports.
3 Create SP (Service
Provider) VLAN
Optional. On the XNCP→:2403S" XNCP" page, create the
SP VLAN. For the steps of creating VLAN, please refer to
802.1Q VLAN
.
78
To Next Page
Loading...
