Instruments
34
• A brief press of the joystick center
will select the required riding mode.
A
15:53
Road
ROAD
MAP
ROAD
ROAD
TC
N
5
2
4
1
3
1. MODE button
2. Current riding mode
3. Joystick
4. Information tray showing riding mode
settings
5.
Riding mode selection panel
• Push the joystick left/right or press
the MODE button to scroll through
the riding mode options.
The selected mode is activated once the
following conditions for switching modes
have been met:
Motorcycle Stationary - Engine Off
•
The ignition is switched ON.
• The engine stop switch is in the
RUN position.
Motorcycle Stationary - Engine Running
•
Neutral gear is selected.
Motorcycle in Motion
Within 30 seconds of selecting a riding
mode the rider must carry out the
following simultaneously:
•
Close the throttle.
• Make sure that the brakes are not
engaged (allow the motorcycle to
coast).
Note
It is not possible to switch into or out
of Rider mode while the motorcycle is in
motion, if the ABS or TC settings are set
to OFF in either of those modes.
In this case, the motorcycle must be
brought to a stop before the riding mode
change can take place.
If a riding mode change is not
completed, the icon will alternate
between the previous riding mode and
the newly selected riding mode until the
change is complete or it is canceled.
The riding mode selection is now
complete and normal riding can be
resumed.
To Next Page
Loading...
