Triumph Rocket 3 R User Manual

Instruments
47
Bike Setup - Hill Hold Control
(if equipped)
Hill hold control assists in making hill
starts. The system (when activated)
will apply the rear brake to hold the
motorcycle in position. The system
will then automatically deactivate and
release the rear brake when it detects
that the motorcycle is attempting to
move off.
To enable/disable hill hold control:
• from the Bike Set Up menu, push
the joystick down to select Hill Hold
and press the joystick center to
confirm.
•
Push the joystick down to select
either Enabled or Disabled.
•
Press the joystick center to confirm
the required selection.
•
The display will then return to the
Bike Set Up menu.
For more information on hill hold
control, see
page 106.
Bike Setup - TSA (Shift Assist)
(if equipped)
Triumph Shift Assist (TSA) triggers a
momentary engine torque change to
allow gears to engage without closure
of the throttle or operation of the
clutch. This feature works for both up
shift and down shift of gears.
The clutch must be used for stopping
and pulling away.
TSA will not operate if the clutch is
applied or if an up shift is attempted
by mistake when in 6th gear. It is
necessary to use a positive pedal force
to make sure there is a smooth gear
shift.
To enable/disable TSA:
• From the Bike Set Up menu, push
the joystick down to select TSA
(Shift Assist) and press the joystick
center to confirm.
•
Push the joystick down/up to select
either Enabled or Disabled.
•
Press the joystick center to confirm
the required selection.
•
The display will then return to the
Bike Set Up menu.
For more information on Triumph Shift
Assist (TSA), see
page 99 .

Triumph Rocket 3 R Specifications

General

Displacement	2458 cc
Bore x Stroke	110.2 mm x 85.9 mm
Compression Ratio	10.8:1
Max Torque	221 Nm @ 4, 000 rpm
Fuel System	Multipoint sequential electronic fuel injection
Final Drive	Shaft
Gearbox	6-speed
Swingarm	Single-sided, cast aluminium
Front Tyre	150/80 R17 V
Rear Tyre	240/50 R16 V
Seat Height	773 mm
Dry Weight	291 kg
Wheelbase	1677 mm
Engine Type	Liquid-cooled, DOHC, inline 3-cylinder
Max Power	165 hp (123 kW) @ 6000 rpm
Exhaust	Stainless steel 3 into 1 headers with 3 exit silencer
Clutch	Hydraulic, torque assist
Frame	Full aluminium frame
Front Suspension	Showa 47 mm upside-down
Rear Suspension	Showa monoshock with piggyback reservoir, adjustable
Front Brakes	Brembo Stylema® 4-piston radial monobloc calipers
Rear Brakes	Brembo 4-piston monobloc caliper
Front Wheel	17 x 3.5 in
Rear Wheel	16 x 7.5 in
Fuel Tank Capacity	18 L
Instrument Display	TFT multi-functional instrument pack with digital speedometer, trip computer, digital tachometer, gear position indicator, fuel gauge, service indicator, ambient temperature, clock and rider modes