151
Spray rust inhibiting oil on all unpainted
metal surfaces to prevent rusting. There
are a variety of products on the market
and your dealer will be able to offer you
local advice. Prevent oil from getting on
rubber parts, brake discs or in the brake
calipers.
Make sure the cooling system is filled
with a 50% mixture of coolant (noting
that HD4X Hybrid OAT coolant, as sup-
plied by Triumph, is premixed and
requires no dilution) and distilled water
solution (see page 102).
Remove the battery, and store it where
it will not be exposed to direct sunlight,
moisture, or freezing temperatures.
During storage it should be given a slow
charge (one Ampere or less) approxi-
mately once every two weeks (see
page 131).
Store the motorcycle in a cool, dry area,
away from sunlight, and with a minimum
daily temperature variation.
Put a suitable porous cover over the
motorcycle to keep dust and dirt from
collecting on it. Avoid using plastic or
similar non-breathable, coated materials
that restrict air flow and allow heat and
moisture to accumulate.
Preparation after Storage
Install the battery (if removed) (see
page 134).
If the motorcycle has been stored for
more than four months, change the en-
gine oil (see page 100).
Check all the points listed in the Daily
Safety Checks section.
Before starting the engine, remove the
spark plugs from each cylinder.
Put the side stand down.
Crank the engine on the starter motor
several times until the oil pressure light
goes out.
Refit the spark plugs, tightening to
12 Nm, and start the engine.
Check and if necessary correct the tyre
pressures.
Clean the entire vehicle thoroughly.
Check the brakes for correct operation.
Test ride the motorcycle at low speeds.
To Next Page
Loading...
Need help?
General
