31
Motorcycle Stationary - Engine Running
• Neutral gear is selected or the
clutch is pulled in.
Motorcycle in Motion
Within 30 seconds of selecting a riding
mode the rider must carry out the fol-
lowing simultaneously:
• Close the throttle
• Pull the clutch in
• Make sure that the brakes are not
engaged (allow the motorcycle to
coast).
Note:
• It is not possible to switch into or
out of TRACK or RIDER mode whilst
the motorcycle is in motion, if the
ABS or TC settings are set to
TRACK or OFF in either of those
modes.
• In this case, the motorcycle must
be brought to a stop before the rid-
ing mode change can take place.
If a riding mode change is not complet-
ed, the icon will alternate between the
previous riding mode and the newly se-
lected riding mode until the change is
complete or it is cancelled.
The riding mode selection is now com-
plete and normal riding can be resumed.
Information Tray
Warning
When the motorcycle is in motion, only
attempt to switch between the infor-
mation tray modes or reset the fuel
information under the following condi-
tions:
- At low speed
- In traffic free areas
- On straight and level roads or
surfaces
- In good road and weather conditions.
Failure to observe this important
warning could lead to loss of
motorcycle control and an accident.
The information tray appears at the
bottom of the display screen and allows
easy access to different motorcycle sta-
tus information.
To view the different information tray
items, push the joystick left/right until
the required information tray item is
shown.
Note:
• To access the information tray, the
warning messages must first be ac-
knowledged, see page 32.
To Next Page
Loading...
Need help?
General
