52
Caution
Do not store the spare key with the
motorcycle as this will reduce all as-
pects of security.
1. Key number tag
In addition to operating the steering
lock/ignition switch, the ignition key is
required to operate the seat lock and
fuel tank cap.
When the motorcycle is delivered from
the factory, two keys are supplied to-
gether with a small tag bearing the key
number. Make a note of the key number
and store the spare key and key num-
ber tag in a safe place away from the
motorcycle.
A transponder is fitted within the key to
turn off the engine immobiliser. To en-
sure the immobiliser functions correctly,
always have only one of the ignition
keys near the ignition switch. Having
two ignition keys near the switch may
interrupt the enable signal between the
transponder and the engine immobiliser.
In this situation the engine immobiliser
will remain on until one of the ignition
keys is removed.
Always get replacement keys from your
authorised Triumph dealer. Replacement
keys must be 'paired' with the motorcy-
cle’s immobiliser by your authorised
Triumph dealer.
Ignition Switch/Steering Lock
Speed Triple S Only
Warning
For reasons of security and safety, al-
ways move the ignition switch to the
OFF position and remove the key when
leaving the motorcycle unattended.
Any unauthorised use of the motorcy-
cle may cause injury to the rider, other
road users and pedestrians and may
also cause damage to the motorcycle.
Warning
With the key in the LOCK or P position
the steering will become locked.
Never turn the key to the LOCK or P
positions while the motorcycle is mov-
ing as this will cause the steering to
lock.
Locked steering will cause loss of mo-
torcycle control and an accident.
To Next Page
Loading...
Need help?
General
