58
If the DRL switch is in the dip beam po-
sition, press the high beam button to
switch the high beam on. Each press of
the button will swap between dip and
high beam.
Note:
• A lighting on/off switch is not fitted
to this model. The rear light and li-
cence plate light all function
automatically when the ignition is
turned on.
• The headlight will function when
the ignition is turned on and the
engine is running.
Models without Daytime Running
Lights (DRL)
Press the high beam button to switch
the high beam on. Each press of the
button will swap between dip and high
beam.
Note:
• A lighting on/off switch is not fitted
to this model. The position light,
rear light and licence plate light all
function automatically when the ig-
nition is turned on.
• The headlight will function when
the ignition is turned on and the
engine is running.
Brake and Clutch Lever Adjusters
Warning
Do not attempt to adjust the levers
with the motorcycle in motion as this
may lead to loss of motorcycle control
and an accident.
After adjusting the levers, operate the
motorcycle in an area free from traffic
to gain familiarity with the new lever
setting.
Do not loan your motorcycle to anyone
as they may change the lever setting
from the one you are familiar with
causing loss of control or an accident.
An adjuster is fitted to both the front
brake and clutch levers. The adjusters
allow the distance from the handlebar
to the levers to be changed to suit the
span of the operator's hands.
Front Brake Lever - Speed Triple RS
Two adjusters are fitted to the brake le-
ver; a span adjuster and a ratio adjuster.
3
2
1
1. Span adjuster wheel
2. Brake lever
3. Ratio adjuster