63
Adjusting the Set Speed While in
Cruise Control
To adjust the set speed while in cruise
control, press and release the:
• RES/+ button to increase the speed
• SET/- button to decrease the speed.
Each press of the buttons will adjust
the speed by 1 mph or 1 km/h. If the but-
tons are held, the speed continuously
increases or decreases in single digit in-
crements.
Stop pressing the adjust button when
the desired speed is shown in the dis-
play.
Note:
• The cruise control set speed display
will flash until the new set speed
has been achieved.
• If riding up a steep incline and
cruise control is unable to maintain
the set speed, the cruise control set
speed display will flash until the
motorcycle has regained the set
speed.
An alternative way to increase the
speed in cruise control is to accelerate
to the desired speed using the throttle
grip and then press the SET/- button.
Deactivating Cruise Control
The cruise control can be deactivated
by one of the following methods:
• Roll the throttle twist grip fully for-
ward.
• Pull the clutch lever.
• Operate the front or rear brake.
• Increase speed by using the throt-
tle for more than 60 seconds.
Press and hold the -/SET button.
Upon deactivation, the cruise control
light will go out in the tachometer but
the SET indicator and set speed will still
be shown in the display screen, indicat-
ing that the cruise control set speed
has been stored.
The cruise control set speed can be re-
sumed as described on page 63,
provided the cruise control has not
been deactivated by turning the ignition
switch to the OFF position.
Resuming the Cruise Control Set
Speed
Warning
When resuming cruise control, always
make sure that the traffic conditions
are suitable for the set speed.
Using cruise control in heavy traffic, on
roads with sharp/blind bends or when
they are slippery, may result in loss of
motorcycle control and an accident.
To Next Page
Loading...
Need help?
General
