64
Cruise control will be deactivated if one
of the following actions has been taken:
• Roll the throttle twist grip fully for-
ward.
• Pull the clutch lever.
• Operate the front or rear brake.
• Increase speed by using the throt-
tle grip for more than 60 seconds.
The cruise control set speed can be re-
sumed by pressing and releasing the
RES/+ button provided a set speed has
been stored.
The motorcycle must be travelling at a
speed between 19 to 100 mph (30 to
160 km/h) and be in 3
rd
gear or higher.
A stored set speed is indicated by the
word SET next to the cruise control
symbol in the display screen.
The stored set speed will remain in the
cruise control memory until the ignition
switch has been turned to the OFF posi-
tion.
Note:
• The cruise control set speed display
will flash until the resumed set
speed has been achieved.
Tyre Pressure Monitoring
System (TPMS) (if fitted)
Warning
The daily check of tyre pressures must
not be excluded because of the fitment
of the TPMS. Check the tyre pressure
when the tyres are cold using an accu-
rate tyre pressure gauge (see
page 127).
Use of the TPMS system to set infla-
tion pressures may lead to incorrect
tyre pressures leading to loss of mo-
torcycle control and an accident.
Note:
• The Tyre Pressure Monitoring Sys-
tem (TPMS) is an accessory option
only available on models fitted with
cast alloy wheels. It must be fitted
by your authorised Triumph dealer.
Tyre pressure sensors are fitted to the
front and rear wheels. These sensors
measure the air pressure inside the tyre
and transmit pressure data to the in-
struments. These sensors will not
transmit the data until the motorcycle is
travelling at a speed greater than
12 mph (20 km). Two dashes will be
shown in the display screen until the
tyre pressure signal is received. The
sensors in each wheel work independ-
ent of each other. Therefore the
sensors can automatically switch on
and update at different times.
To Next Page
Loading...
Need help?
General
