27
Fuel Gauge
The fuel gauge indicates the amount of
fuel in the tank.
1. Fuel gauge
With the ignition switched on, a filled
line indicates the fuel remaining in the
fuel tank.
Note:
• The fuel gauge colours may vary
depending on the theme or style
chosen.
The gauge markings indicate intermedi-
ate fuel levels between E (empty) and
F (full).
The low fuel warning light will illuminate
when approximately 3.5 litres of fuel is
remaining in the tank and you should
refuel at the earliest opportunity.
The range to empty and instantaneous
fuel consumption will be also shown in
the information tray. Press the joystick
centre to acknowledge and hide the low
fuel warning.
After refuelling, the fuel gauge and
range to empty information will be up-
dated only while riding the motorcycle.
Depending on the riding style, updating
could take up to five minutes.
Service Interval Announcement
The service interval announce-
ment shows the total distance or time
that the motorcycle has remaining
before a service is required. When the
remaining distance is 0 miles (0 km), or
the remaining time is 0 days, the service
symbol will remain on until the service
has been carried out and the system
has been reset by your authorised
Triumph dealer.
If the service is overdue then OVERDUE
will be shown and the service symbol
will be shown in the information tray.
When the service has been carried out
by your authorised Triumph dealer, the
system will be reset.
The distance to the next service or
OVERDUE message will also be shown
on the instrument start up screen when
the ignition is turned on.
The service symbol will also be shown if
a fault has occurred and the ABS and/
or MIL warning lights are illuminated.
Contact an authorised Triumph dealer
as soon as possible to have the fault
checked and rectified.
Ambient Air Temperature
The ambient air temperature is dis-
played as either
o
C or
o
F.
When the motorcycle is stationary the
heat of the engine may affect the accu-
racy of the ambient temperature
display.
Once the motorcycle starts moving the
display will return to normal after a
short time.
To change the temperature from °C or
°F see page 46.
To Next Page
Loading...
Need help?
General
