56
Left Handlebar Switches
All Models
5
6
1
2
3
4
7
1. Cruise control adjust switch
2. Daytime Running Lights (DRL) switch
(if fitted)
3. MODE button
4. Direction indicator switch
5. Joystick button
6. Horn button
7. High beam button
The following sections describe the han-
dlebar buttons and switches functions.
Cruise Control Adjust Button
The cruise control adjust button is a
two way switch with the top marked
RES/+ and the bottom marked SET/-.
For more information on cruise control
operation, see page 61.
Daytime Running Lights (DRL)
Switch (if fitted)
When the ignition is switched
ON and the daytime running lights
switch is set to DRL mode, the daytime
running lights warning light will illumi-
nate.
The daytime running lights and low
beam headlights are operated manually
using the DRL switch. Push the switch
forward to the top for DRL mode, and
push the switch rearward to the bottom
for low beam headlight mode.
Warning
Do not ride for longer than necessary
in poor ambient light conditions with
the Daytime Running Lights (DRL) in
use.
Riding with the daytime running lights
when dark, in tunnels or where poor
ambient light is apparent may reduce
the riders vision or dazzle other road
users.
Dazzling other road users or reduced
vision in low ambient light levels may
result in loss of motorcycle control and
an accident.
Note:
• During daylight hours the daytime
running lights improve the motor-
cycles visibility to other road users.
• Low beam headlights must be used
in any other conditions unless the
road conditions allow for high beam
headlights to be used.
To Next Page
Loading...
Need help?
General
