24
Direction Indicators
When the indicator switch is
turned to the left or right, the indicator
warning light will flash on and off at the
same speed as the direction indicators.
Hazard Warning Lights
To turn the hazard warning lights on or
off, press and release the hazard warn-
ing light switch.
The ignition must be switched ON for
the hazard warning lights to function.
The hazard warning lights will remain on
if the ignition is switched off, until the
hazard warning light switch is pressed
again.
High Beam Button
When the high beam button is
pressed the high beam will be switched
on. Each press of the button will swap
between dip and high beam.
Note:
• If daytime running lights are fitted
to the motorcycle, the high beam
button has additional functionality.
If the DRL switch is in the daytime run-
ning lights position, then press and hold
the high beam button to turn the high
beam on. It will remain on as long as the
button is held in and will turn off as
soon as the button is released.
Note:
• A lighting on/off switch is not fitted
to this model. The rear light and li-
cence plate light all function
automatically when the ignition is
on.
• The headlight will function when
the ignition is on. The headlight will
go off while pressing the starter
button until the engine starts.
Daytime Running Lights (DRL)
When the ignition is switched
ON and the daytime running lights
switch is set to DAYTIME RUNNING
LIGHTS, the daytime running lights
warning light will illuminate.
The daytime running lights and low
beam headlights are operated manually
using a switch on the left hand switch
housing, see page 56.
Warning
Do not ride for longer than necessary
in poor ambient light conditions with
the Daytime Running Lights (DRL) in
use.
Riding with the Daytime Running
Lights when dark, in tunnels or where
poor ambient light is apparent may re-
duce the riders vision or dazzle other
road users.
Dazzling other road users or reduced
vision in low ambient light levels may
result in loss of motorcycle control and
an accident.
To Next Page
Loading...
Need help?
General
