54
QUICK START Position
The QUICK START position operates the
electric starter allowing for a quicker
engine start.
From the ignition off, press and hold the
engine start/stop switch in the QUICK-
START position with all the correct
conditions met, to start the motorcycle.
For more information, see page 78.
RUN Position
The engine start/stop switch must be in
the RUN position for the motorcycle to
operate.
STOP Position
The STOP position stops the engine.
Note:
• Although the engine stop position
stops the engine, it does not turn
off all the electrical circuits and
may cause difficulty in restarting
the engine due to a discharged bat-
tery.
Power ON/OFF Position
The Power ON/OFF position switches
the electrical circuits and the instru-
ment display between on or off. This
allows access to the instrument display
without starting the engine.
Caution
Do not leave the switch in the Power
ON position for a long period of time as
this may cause damage to electrical
components and will discharge the
battery.
Hazard Warning Lights Button
To turn the hazard warning lights on or
off, press and release the hazard warn-
ing light button.
The ignition must be switched on for the
hazard warnings lights to be activated,
but the hazard lights will remain active
if the ignition is switched off until the
hazard warning light button is pressed
again.
Steering Lock Button
To lock the motorcycle, turn the handle-
bar fully to the left and press the
steering lock button.
Warning
For reasons of security and safety, al-
ways make sure the steering lock is on
when leaving the motorcycle unattend-
ed.
Any unauthorised use of the motorcy-
cle may cause injury to the rider, other
road users and pedestrians and may
also cause damage to the motorcycle.
To Next Page
Loading...
Need help?
General
