How to Ride the Motorcycle
88
Tyres
High speed operation is hard on tyres,
and tyres that are in good condition are
crucial to riding safely. Examine their
overall condition, inflate to the correct
pressure (when the tyres are cold), and
check the wheel balance. Securely fit
the valve caps after checking tyre pres-
sures. Observe the information given in
the maintenance and specification sec-
tions on tyre checking and tyre safety.
Fuel
Have sufficient fuel for the increased
fuel consumption that will result from
high speed operation.
Caution
In many countries, the exhaust system
for this model is fitted with a catalytic
converter to help reduce exhaust
emission levels.
The catalytic converter can be perma-
nently damaged if the motorcycle is
allowed to run out of fuel or if the fuel
level is allowed to get very low.
Always make sure you have adequate
fuel for your journey.
Engine Oil
Check that the engine oil level is correct.
Make sure that the correct grade and
type of oil is used when topping up.
Drive Chain
Make sure that the drive chain is cor-
rectly adjusted and lubricated. Inspect
the chain for wear and damage.
Coolant
Check that the coolant level is at the
upper level line in the expansion tank.
Always check the level with the engine
cold.
Electrical Equipment
Make sure that all electrical equipment
such as the headlight, rear/brake light,
direction indicators and horn all work
correctly.
Miscellaneous
Visually check that all fixings are tight.
To Next Page
Loading...
Need help?
General
