UniPOS FS5200E - Function Factory Settings

UniPOS Fire Extinguishing Control Panel FS5200Е
Instruction Manual Page 58
Revision 7/06.12 of 63
13.4.6. The function Factory Settings returns
the parameters of the fire extinguishing
control panel repeater to their default settings.
The specific values of the parameters are
given in the previous sections of the
instruction manual.
1 2 3
13.4.7. Function Clear Archive
This function allows the archive to be
cleared from the energy independent
memory.
Press the button to activate the
function and to clear the archive.
Important: The fire counter is not cleared.
It is reset in a special mode (Access Level 4).
1 2 3
13.4.8. Function new Password
This function serves to change the
existing password for Access Level 3. The
admissible values are from 0000 to 9999.
The factory setting is „0000”.
1 2 3
14. Extinguishing Control Algorithm
The algorithm to control the outputs and the indication depending on the input influences and
the set parameters for the fire extinguishing control panel operation is shown on Drawing 12.
.