Unipulse F381A - Page 107

98
5 COMMUNICATIONS
98
COMMUNICATIONS
Chapter
5
② Writing Comparison Waveform (LO limit)
F381A’s return
(In normal processing)
Command received by the F381A
Header (If there is no header, no data will result.)
（ STX ） Delimiter 00W0 010+00 03
（ STX ） Delimiter N1G
F381A’s return
(In abnormal condition)
Header (If there is no header, no data will result.)
NG No.
1: Receipt of a statement different from the command format
2: Attempt to write a set value outside the setting range
4: Attempt to write a set value through communications
during measurement
5: Attempt to write while protecting
Hyphen(2dH)
Data No.
0000 to 2047
Load data
-9999 to +9999
Fixed at 0
Waveform selection
1: Comparison Waveform (HI limit)
2: Comparison Waveform (LO limit)
Space (20H)
0V02SP0 00 .-1+0033WA Delimiter
The decimal place should be the same
as that of load calibration.
If different, the decimal point is ignored.
Example) When the decimal place is 0.000,
if +23.42 is specified,
it is handled as +2.342.
F381A’s return
(In normal processing)
Command received by the F381A
（ STX ） 0WVA2SP00 0000+-313. Delimiter
Repeated for 2047 data by adding “1” to Data No. after
confirmation of normal processing to change all the waveform data.
Repeated for desired data by specifying Data No. to change part of
the waveform.
Host
(Transmission to the F381A)
Host
(Transmission to the F381A)
0V02SP0 10 .-1+0072WA Delimiter
（ STX ） Delimiter N1G
F381A’s return
(In abnormal condition)
Header (If there is no header, no data will result.)
NG No.
1: Receipt of a statement different from the command format
2: Attempt to write a set value outside the setting range
4: Attempt to write a set value through communications
during measurement
5: Attempt to write while protecting