Unipulse F381A - Page 73

64
4 SETTINGS AND CALIBRATIONS
64
SETTINGS AND CALIBRATIONS
Chapter
4
- Bottom
The minimum value (bottom value) is held.
- P-P (Peak to Peak)
The difference between the peak value and
the bottom value is held.
- Relative Maximum
Detection is carried out from the point at
which the Detection Start Load is crossed,
and when the relative maximum detection
conditions are met, the relative maximum is
held.
- Relative Minimum
Detection is carried out from the point at
which the Detection Start Load is crossed,
and when the relative minimum detection
conditions are met, the relative minimum is
held.
Valid section
OFF
ON
Section
Start point End point
Detection and hold Hold
Hold
input
(Time or DPM (Front))
Section
End point Start point
(DPM (Back))
Sensor
input
value
Indicated
value
Valid section
OFF
ON
Detection and hold Hold
Indicated value=0
Sensor input
Reference line
(Here is the reference
only in the valid section.)
Indicated value=0
Hold
input
Section
Start point End point
(Time or DPM (Front))
Section
End point Start point
(DPM (Back))
value
Indicated
value
Valid section
OFF
ON
Detection Hold
Detection
Start Load
Hold
input
Section
Start point End point
(Time or DPM (Front))
Section
End point Start point
(DPM (Back))
Sensor input
value
Indicated
value
Valid section
OFF
ON
Detection
Hold
Detection
Start Load
Hold
input
Section
Start point End point
(Time or DPM (Front))
Section
End point Start point
(DPM (Back))
Indicated
value
Sensor input
value