Unipulse F381A - Page 79

70
4 SETTINGS AND CALIBRATIONS
70
SETTINGS AND CALIBRATIONS
Chapter
4
5. Relative Comparison
Select whether waveform comparison is made as standard or by
relative value.
Operation
Setting range (Off, On)
Main screen → Setting → Work Setting →Wave Setting →Relative
6. Reference Point of Relative Comparison
Set the reference point for making waveform comparison by
relative movement. This setting can be made only when the
setting of Relative Comparison is On.
Setting range
X-axis:
Time or displacement (Front) (0 to 2047 × Measurement Length/2000)
Displacement (Back) (-2047 to 0 × Measurement Length/2000)
Operation
Y-axis: (-9999 to 9999)
Main screen → Setting → Work Setting →Wave Setting →Relative Point
7. Waveform Save
Check and save the waveform.
If there is no problem, press .
The present waveform is not saved until is pressed.
Operation
Main screen → Setting → Work Setting →Wave Setting →Wave Save
When not using comparison waveforms ...
1. Press on the Registration of Reference Waveform screen, and select
.
2. Since the Registration of Reference Waveform screen is restored, press .
3. If the setting of Relative Comparison is On, set it to Off.
4. Press Wave Save, and press .
Upon completion of creation/processing of a waveform, be sure to check and
save it by Waveform Save.
Point